ASTM D1000 Test Standard for Pressure Sensitive Adhesive Coated Tape Used in Electronic Applications

EUROLAB laboratory provides testing and compliance services within the scope of ASTM D1000 standard. ASTM D1000 covers procedures for testing pressure sensitive adhesive coated tapes for use as electrical insulation. These bands are classified as:

1st Class Adhesive Coated Tapes

Non-elastoremic liners made from materials such as plain or creped paper, coated or uncoated fabric, cellulose ester films, polyethylene polyester films, fluorocarbon polymer films, composite filament films, polyamide films, polyimide films and combinations thereof are in class 1.

2st Class Adhesive Coated Tapes

It covers elastomeric liners characterized by both high resilience and significant recovery. Vinyl chloride and copolymers, Vinylidene chloride and copolymers, and Polyethylene and copolymers
made of materials such as

ASTM D1000 Test Procedures

Adhesion strength and support to steel at room temperature
Adhesion strength and support to steel at low temperatures
Bond strength after solvent dipping
Tensile strength and elongation at room temperature
Tensile strength and elongation at low temperatures
conditioning
Curling and twisting
Dielectric breakdown voltage
Effect of accelerated aging on high temperature bands
Marking
Flammability
Hazards/precautions
Insulation resistance at high humidity
Tape length on roll
oil resistance
Puncture resistance
Resistance to accelerated aging (heat and humidity)
Sampling
relaxation force at room temperature
relaxation force at low temperatures

Values ​​in SI units are standard unless otherwise stated. If a measurement value is followed by an inch-pound or imperial value in parentheses, the second value is likely to be an approximation only and is for informational purposes only. The first specified value is the preferred unit.

With the difference of EUROLAB, its rich engineer staff gives you test services within the scope of ASTM D1000 standard with devotion.